PDA

Ver la Versión Completa : SE COMPRA Compro ECU motor de 1.8t AUM



tizon69
24/02/2010, 18:12
Buenas,compro centralita motor para golf IV motor 1.8t 150cv letras de motor AUM la referencia es esta 06A906032DR y en bosch 0261206887

1Saludo

Borja_perez
24/02/2010, 19:55
Me apunto la referencia por si me paso por la torre y veo alguna se me caiga en la cintura xD

Un saludo

De todos modos el problema que tu tienes con la centralita es el sensor de presion o no se que no??? lo digo por que yo tengo una centralita referencia 038 906 012 AP de un coche diesel y alomejor te podria valer algo...

tizon69
24/02/2010, 20:14
En un principio es el sensor de altitud,el mio lleva MAP en intercooler,es el componente este
[Only registered and activated users can see links] ([Only registered and activated users can see links])
muchas gracias a ver si hay suerte por que luego en la torre no hay casi de nada
1Saludo

frejo
24/02/2010, 22:32
Te comento lo mismo que a otro compañero,mañana tengo que hacer gestiones en un par de desguaces de Asturias,si te interesara te miro algo.

tizon69
24/02/2010, 22:51
Ok,si me haces el favor,te lo agradezco

frejo
25/02/2010, 12:10
No tienen nada de unidades de 1.8 T,algun turbo me dijo que tenia,y compresor de AA,pero nada mas.
Saludos.

tizon69
25/02/2010, 15:10
muchas gracias seguire buscando
1sSaludo

tizon69
27/02/2010, 17:23
Buenas,al final he comprado la ECU con la misma ref que la mia,la he tenido que comprar fuera,a ver si me llega,cuando la tenga que pasos he de seguir para codificarla??
mi coche tiene inmo2, solamente hay que adaptar cuadro con llaves,si la centralita que he comprado que es del mismo año que el mio 2001 y trae inmo2 no me haria falta adaptar nada??por el contrario si es inmo3 tendria que adaptar cuadro,ECU y llaves??

frejo
27/02/2010, 22:13
En la wiki viene esto para inmo II:


Immobilizer 2 ECU Swapping
Updated 29 Mar. 2005



Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk. As always, you should refer to a Factory Repair Manual ([Only registered and activated users can see links]) for your vehicle!
Immobilizer II:
The immobilizer will prevent the car from running without a matching key microchip. There is a symbol in the instrument cluster showing a key inside a car. If a new (or different ECU) is installed in the vehicle, the immobilizer will prevent the car from running and will cause the symbol to flash. Here is the procedure to introduce a new ECU to the instrument cluster. This must be performed each time ECU's are exchanged. This does not apply to installing a "chip" in the same ECU that is already aligned with the car.
Immo-3 knows your car's VIN. Access 17-Instruments (or separate 25-Immobilizer on vehicles that are set up that way) and look at the first "Extra" field.

If you see something like: "Immo-ID VWZ7Z0W0648696" You've got Immo-2 (or maybe even Immo-1 in earlier non-US models).

If you see something like "WVZKB58001H231169 VWZ7Z0W0648696" You've got
Immo-3. The first 17-digit string is the VIN. The second 14-digit string in the Immo-ID.


Install the new ECU in the car
[Select]
[17 - Instruments]
[Adaptation - 10]
Leave channel at "00"
[Read]
[Save]

[Done, Go Back]
[Close Controller, Go Back - 06]
[Exit]

Turn ignition OFF for 15 seconds. Start vehicle.

Note: For cars with a separate Immobilizer (Includes 2000+ EuroVan, Cabrio, and many older non-US models), use [25 Immobilizer] instead of [17 - Instruments]. The rest of the procedure is the same.


Si el cuadro es inmo III tengo entendido que te vale,si fuese al contrario si tendrias problemas,pero no lo se seguro,aver si alguien que lo haya hecho nos puede informar mejor.

tizon69
28/02/2010, 12:33
Gracias,esperemos que la ECU que he comprado estubiese montado con un cuadro inmo2,asi no tendre problemas,si es inmo3 pues seguire el procedimiento para adaptar llaves con inmo3,entiendo en el procedimiento para inmo2 hay que ir al canal 17 y alli a adaptacion,leer el canal 0 grabar y salir,haber si alguien nos ilumina un poco mas

Gu4rDi4N
03/03/2010, 07:42
Siempre puedes comprar una ECU en USA de AWW (AUM aqui) y anular Inmo :P

tizon69
03/03/2010, 20:43
Siempre puedes comprar una ECU en USA de AWW (AUM aqui) y anular Inmo :P

Al final la he comprado a una persona en Gran Bretaña,me ha salido junto con portes 93,44€,a ver si me llega en esta semana y la monto el finde que viene,es con la misma referencia que la mia,del mismo año y tiene unos 135000km,ya veremos si soy capaz de hacer que arranque el coche

Gu4rDi4N
03/03/2010, 20:58
Sino te le busco comprador :D

tizon69
04/03/2010, 20:10
Ok,ya te digo como ha ido la cosa
1Saludo